Bus Stop

The bus stop was started by creating 2 rectangles, 1 triangle bigger than the other. Using the inset too the poser holes where created and pushed into the frame. The legs on the base are extruded down, at an equal height.

The top of the bus stop was created by bevelling out to create the holder for top.

The top of the shelter was extrude out and over the rectangles. The angles of extrudes where rotated using to suit the angle needed. The bar that holds the top up is extrude out of the base of the roof.

Once the outer shape of the bus stop had been made the seat was added in this was added in as 2 panels, one panel for the upper lip and the other for the lower lip. this was created using a rectangle to create the seat with the legs extruded out the base of the seat. The back of the seat was extruded up out of the seat and shaped into the back of the seat.

The textures where applied to the bus stop, using a multi sup object texture.

The eyes where added as suns in the poster, these where made using Unwrap UVW, this was to keep the texture as it is when the bus stop leans and to change the picture of the eyes for the watching scene.